From the Node SSH Terminal run these commands.
1. Show current IP addresses
ip -br addr
2. Check IPv6 settings
sysctl net.ipv6.conf.all.disable_ipv6 net.ipv6.conf.default.disable_ipv6
3. Check the active network connection
nmcli -t -f DEVICE,TYPE,STATE,CONNECTION device status
4. Save IPv6-disabled configuration
sudo nmcli connection modify "Wired connection 1" ipv6.method disabled
5. Verify the saved setting (should say disabled)
nmcli -g ipv6.method connection show "Wired connection 1"
6. Apply the saved setting to Ethernet
sudo nmcli device reapply eth0
7. Confirm Ethernet has an IPv4 address and no IPv6 address
ip -br addr
8. Check that the ASL3 Asterisk service is active
sudo systemctl is-active asterisk
Optional - Re-enable IPv6 on Ethernet
sudo nmcli connection modify "Wired connection 1" ipv6.method auto
sudo nmcli device reapply eth0
Robert (WROV324)
Ray (WRFD401)
From the Node SSH Terminal run these commands.
1. Show current IP addresses
ip -br addr
2. Check IPv6 settings
sysctl net.ipv6.conf.all.disable_ipv6 net.ipv6.conf.default.disable_ipv6
3. Check the active network connection
nmcli -t -f DEVICE,TYPE,STATE,CONNECTION device status
4. Save IPv6-disabled configuration
sudo nmcli connection modify "Wired connection 1" ipv6.method disabled
5. Verify the saved setting (should say disabled)
nmcli -g ipv6.method connection show "Wired connection 1"
6. Apply the saved setting to Ethernet
sudo nmcli device reapply eth0
7. Confirm Ethernet has an IPv4 address and no IPv6 address
ip -br addr
8. Check that the ASL3 Asterisk service is active
sudo systemctl is-active asterisk
Optional - Re-enable IPv6 on Ethernet
sudo nmcli connection modify "Wired connection 1" ipv6.method auto
sudo nmcli device reapply eth0
Robert (WROV324)
Ray (WRFD401)
