ASL3 – Disable IPv6
From the Node SSH Terminal run these commands.
1. Show current IP addresses
ip -br addr
2. Check IPv6 settings
sysctl net.ipv6.conf.all.disable_ipv6 net.ipv6.conf.default.disable_ipv6
3. Check the active network connection
nmcli -t -f DEVICE,TYPE,STATE,CONNECTION device status
4. Save IPv6-disabled configuration
sudo nmcli connection modify “Wired connection 1” ipv6.method disabled
5. Verify the saved setting (should say disabled)
nmcli -g ipv6.method connection show “Wired connection 1“
6. Apply the saved setting to Ethernet
sudo nmcli device reapply eth0
7. Confirm Ethernet has an IPv4 address and no IPv6 address
ip -br addr
8. Check that the ASL3 Asterisk service is active
sudo systemctl is-active asterisk
Optional – Re-enable IPv6 on Ethernet
sudo nmcli connection modify “Wired connection 1” ipv6.method auto
sudo nmcli device reapply eth0
Robert (WROV324)
Ray (WRFD401)